ASTM F738 PDF

Superfast Fasteners India Pvt. ISO Certified. CE Marking Certified. Eight groups of stainless steel alloys are covered, including three austenitic grades A1, A2, and A4 , one ferritic grade F1 , three martensitic grades C1, C3, and C4 , and one precipitation hardening grade P1. The chemical composition of the material shall conform to the requirements prescribed. Tensile strength, yield strength, elongation, and torsional strength shall be tested to meet the requirements prescribed.

Author:JoJolrajas Nikree
Country:Panama
Language:English (Spanish)
Genre:Art
Published (Last):14 May 2018
Pages:226
PDF File Size:18.46 Mb
ePub File Size:9.70 Mb
ISBN:537-1-58456-954-7
Downloads:10832
Price:Free* [*Free Regsitration Required]
Uploader:Akibei



Superfast Fasteners India Pvt. ISO Certified. CE Marking Certified. Eight groups of stainless steel alloys are covered, including three austenitic grades A1, A2, and A4 , one ferritic grade F1 , three martensitic grades C1, C3, and C4 , and one precipitation hardening grade P1. The chemical composition of the material shall conform to the requirements prescribed.

Tensile strength, yield strength, elongation, and torsional strength shall be tested to meet the requirements prescribed. This specification covers the material, dimensions, and construction of 5 and gal 20 and L tanks purchased to store and dispense lubricating oils.

The tanks are industrial safety cans mounted on a T-bar bracket, complete with drip tray. Internal air pressure test shall be performed on the tank to meet the requirements prescribed. There should be no visible seam leakage when subjected to underwater or soap bubble test. Scope 1. The property classes with the permissible alloys for each are listed in Table 1. The chemical and mechanical requirements specified for all property classes, except as given in 1.

No other units of measurement are included in this standard. This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

I Washers Manufacture of D. All rights reserved.

ATMEGA W PRAKTYCE PDF

ASTM F738 Bolts

A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. Scope 1. The property classes with the permissible alloys for each are listed in Table 1. The chemical and mechanical requirements speci? This standard does not purport to address the safety problems associated with its use.

AERMEC DIAGRAMMA PSICROMETRICO PDF

ASTM F738 Class A1-50 S20300 ASTM F738M

This specification covers the chemical and mechanical requirements for stainless steel metric bolts, screws, and studs with nominal thread diameters M1. Formerly under the jurisdiction of Committee F16 on Fasteners, this specification was withdrawn in December This standard is being withdrawn without replacement due to its limited use by industry. The property classes with the permissible alloys for each are listed in Table 1. The chemical and mechanical requirements specified for all property classes, except as given in 1. No other units of measurement are included in this standard.

3RV1021 1KA10 PDF

.

DN 118 COPAM PDF

.

Related Articles